EPA Method 9013

Summit Environmental Technologies prides itself in its expansive testing capabilities in a variety of different fields. To find out if Summit conducts this test, contact us at 330-253-8211 today.

PDF IconView Actual EPA Method 9013 (PDF File)


EPA Method 9013:
CYANIDE EXTRACTION PROCEDURE FOR SOLIDS AND OILS

Summary:
If the waste sample contains so much solid, or solids of such a size as to interfere with agitation and homogenization of the sample mixture in the distillation flask, or so much oil or grease as to interfere with the formation of a homogeneous emulsion, the sample may be extracted with water at pH 10 or greater, and the extract distilled and analyzed by Method 9010. Samples that contain free water are filtered and separated into an aqueous component and a combined oil and solid component. The nonaqueous component may then be extracted, and an aliquot of the extract combined with an aliquot of the filtrate in proportion to the composition of the sample. Alternatively, the components may be analyzed separately, and cyanide levels reported for each component. However, if the sample solids are known to contain sufficient levels of cyanide (about 50 ?g/g) as to be well above the limit of detection, the extraction step may be deleted and the solids analyzed directly by Method 9010. This can be accomplished by diluting a small aliquot of the waste solid (1-10 g) in 500 mL water in the distillation flask and suspending the slurry during distillation with a magnetic stir-bar.

Scope:
The extraction procedure described in this method is designed for the extraction of soluble cyanides from solid and oil wastes. The method is applicable to oil, solid, and multiphasic samples. This method is not applicable to samples containing insoluble cyanide compounds.

Report Number:
SW-846 Ch 5